The 3 Biggest Disasters In Peugeot 308 Key Fob History

The 3 Biggest Disasters In Peugeot 308 Key Fob History

Peugeot 308 Key Fob Replacement

Peugeot's 308 could be catching on a little but it's still appealing. It's not the most luxurious car in its class, but it is an enjoyable and comfortable drive.

We get asked frequently at Coded Car Keys to replace peugeot key fobs. These tips can aid whether the issue is ongoing or intermittent.

Water Damage

If you leave your key fob in a pool or get it wet during kayaking, swimming, canoeing, rafting, or canyoning, it's more likely to sustain water damage. The best way to avoid this from happening is to always keep it in a dry bag when you're going outdoors or doing things where the fob might be exposed to large amounts of water.

It's also important to make sure that the fob has dried out prior to opening it up and then use it again. If you smell any odors from the fob (such as industrial fluid or windshield washer fluid) This is a further indicator that it is submerged.

A wet circuit board can cause the battery to lose its charge, or even explode. If you're able to pull your key fob 308 out of whatever body of water it was stuck in turn the button upside down and shake it out as much water as you can before opening the case. Take the battery out, and then wipe the circuit board down using a cotton swab which is dipped in 90 percent alcohol.



Other reasons why your Peugeot 308 remote keyless entry system could fail to function include an empty coin battery problems with the receiver module signal interference, an electronic chip that is damaged. If none of these are the cause it is possible to reset the system by disconnecting 12 volt battery from the car for 15 minutes.

Dead Coin Battery

Peugeot cars are equipped with a remote-start system that allows the driver to start the car from a distance, warming up or cooling down the car prior to entering. This feature is extremely beneficial, especially during winter's cold and chilly months. However, it is possible that the remote stop system stops operating due to a range of reasons, including a dead coin battery.

A coin-shaped battery in the key fob has a lifespan of two to four years, based on how often it's utilized and where it was purchased. The date of use is usually found on the packaging or listed in the instruction manual.

If the key fob stopped functioning after exposure to clean tap water it is recommended to remove the battery, clean the electronic chip using a paper towel and isopropyl alcohol, and then dry it thoroughly before replacing it. If the key fob was exposed to salty or soapy water, it could have caused the chip to be damaged. You'll need to replace it.

If  The KeyLab 're not sure the battery is in good condition you can check its voltage with a multimeter set to your car's voltage range, and connect it to the minus and plus terminals. If the voltage is less than 12-13 volts you need to replace the battery. You can also reset your onboard computer by disconnecting and reconnecting the 12 volt batteries in reverse order. (positive cable first then negative cable). The engine should now start.

Faulty Receiver Module

If you aren't seeing the "Key Detected" It could be that your receiver module is not working properly. It's the part which sends out a signal when your key fob turns on. It also acts as an alarm that stops the vehicle from starting without the correct key.

This could be due to a range of causes including water damage or simply ageing. If the electronic chip within your Peugeot 308 keyfob has been damaged by dirty tap water it could be because the keyfob was contaminated with it. In this scenario, you'll need to take it out and clean it thoroughly using isopropyl or an electronic cleaner. Once it's dry you can put the battery back in and test it again.

If the issue continues to persist, it is a good idea that you visit an area Peugeot expert or locksmith. They'll be able to employ a diagnostic tool assist in identifying the problem and repair it for you.

The loss of your Peugeot car keys could be an extremely stressful experience. However, a professional auto locksmith can address the problem in minutes. They can cut a new key and programme it to your vehicle, ensuring you're back to the road as quickly as possible. Click here to locate a locksmith in your area.

Faulty Electronic Chip

The electronic chip that is in your Peugeot 308 key fob is a very vital component of the remote control system. If the chip is damaged, you may experience difficulties starting your vehicle or receive a message saying "anti-theft". If this occurs, the only way to fix the problem is to obtain a new key. Professional auto locksmiths are able to provide this service in the shortest time.

The chip in the key fob of your Peugeot 308 may fail due to different reasons, such as sweat, water damage or dirt. If your Peugeot 308 key fob has been exposed to soapy water, clean it right away. You can wipe the electronic component using a paper towel soaked in isopropyl Alcohol. The battery must then be allowed to dry completely.

Radio interference can cause the key fob's functionality to cease. This could be caused by other devices operating on the same frequency as your Peugeot key fob. It can also be caused by bad weather or objects that are in the vicinity of the vehicle. If you encounter this issue it is advised to visit the Peugeot dealership.

The Peugeot 207/308 key fob is very delicate and requires special care. You shouldn't drop it or throw it around. If you lose it, try to find it as soon as you can. You can reset all the on-board computers by disconnecting the 12 volt battery for a few minutes. Be sure to disconnect the negative first, and then the positive.